This is my version of a 3D Turkey I saw in Cricut's Project Center. I cut this out at 4"
|I glued the two turkey bodies together, then I glued on all the decorative pieces, lastly the dark tail feather to the yellow tail feathers. Then I used a brown fine tip marker and "stitched" around everything.|
|The split in the yellow feather goes over the tabs on the back of the body. Since I used two bodies to make a turkey I was able to attach to the tabs as shown in the photo. If using one body, spread one tab left and one tab right.|
|Add the large orange tail feathers and you have a completed turkey just like the booklet that comes with the cartridge.|
|I went back and added googly eyes and white gel pen on the dark cardstock to add a bit of detail.|